Welcome to Surmountor!            English           España
User name: 
password: 
    
Products
Home > Products > LED Controller/Sensor Switch > Hand Sensor with Dimmer IR001-D
Hand Sensor with Dimmer IR001-D
> Turn on or off with above repeatable steps.
> Hold hand over the sensor for 3 seconds for dimming from 1%~100%, will turn off when the hand pass over the sensor.
> This sensor will memorize the status of the dimming in DC12V-24V.
Product description

 
Description Dimension Voltage Load
Hand sensor switch with dimmer 10x55mm 12-24VDC Max. 8 Amps.

V+    ----DC input positive
V-    ----DC input negative
DC input parameters    
               Input Voltage    12-24V DC Max.
               Input Current    Max. 8A
LED+  --- Output to LED Strip positive
LED-  --- Output to LED Strip negative
The The two IR diodes head should be put out of PC cover as the picture below.

●FuFunction:
1, LED Strip originally “off” and the little indicate light on PCB are “ on” when the power is connected.
2, When object pass over the sensor (less than 3s), the lamp will turn on/off.
   a, The LED lamp connected to the output the IR Sensor switch will turn on when the hand pass
       over the IR switch within 10cm in distance, and will turn off when the hand pass over the IR
        switch again.
   b, Hold hand over the sensor for 3 seconds for dimming from 1%~100%, will turn off when the hand
       pass over the sensor.
   C. This sensor will memorize the status of the dimming in DC12V-24V.
3. The sensor switch will turn on or off with above repatable steps.
Detective Distance: ≤10cm.
 
Installation Instructions
Step I: Cut 2pcs Φ5mm holes at the fixture.
Step II: Put the Detector head into the Φ5mm holes.
Step III: Connect wires to the iput end and output end of the control PCB.

copyright © 2015 Shenzhen Surmountor Lighting CO Limited
Follow Us: